Dolmar MG5300.4 Original Instruction Manual page 13

To loosen the strap, pull up the end of the fastener.
► 1. Fastener
Hip belt
Optional accessory
The hip belt enables the operator to carry the tool more
stably.
CAUTION:
Make sure to release the hip belt
buckle before unloading the blower.
Adjusting the control lever position
Move the control handle along the swivel pipe to the
most comfortable position. Then tighten the control
handle with the clamp screw.
► 1. Clamp screw
Blower Operation
1
1. While operating the blower, adjust the throttle trig-
ger / throttle lever so that the wind force is appropriate
for the work location and conditions.
2. Adjusting engine speed.
Engine speed increases by pulling the throttle trigger. To
decrease the engine speed, loosen the throttle trigger.
The cruise control function allows the operator to main-
tain a constant engine speed without pulling the trigger
lever. To increase the engine speed, turn the stop con-
trol lever to high speed. To decrease the engine speed,
turn the stop control lever to low speed.
► 1. Throttle trigger 2. Stop control lever
Transporting the blower
CAUTION:
sure to stop the engine.
NOTICE:
or put a heavy object on it. It may damage the
1
machine.
NOTICE:
position whenever transporting or storing.
Transporting or storing in a position that is not upright
may cause oil to spill inside the blower engine. This
may result in oil leaks and white smoke from burning
oil, and the air cleaner may become dirty with oil.
NOTICE:
porting. Otherwise the blower housing may be
damaged.
13 ENGLISH
2
1
When transporting the blower, be
Do not sit or stand on the blower
Maintain the blower in an upright
Do not drag the blower when trans-