INIM SMARTLOOP 0051-CPR-0225 Manual page 26

Note:
To modify an existing device: use keys

press
Point x/yy
Type : ttt
KL
= Select Type
J
Point x/yyy <Description>
Type : ttt
Activation Type : <Activation>
Pre-alarm :
8.4.3 Removing a device from the loop
From panel: <key>, Programming, <code>, Configuration, Modify Configuration, Manual Configuration,
Loop, x Loop x, Remove Point, 
or:
<key>, 8, <code>, 1, 2, 2, 1, x, 3
It is possible to delete a device from the loop via the panel:
Point x/yyy <Point Description>
Type : ttt
The device will be deleted ....
CONTINUE? Enter=YES
8.4.4 Adding/Deleting RS485 BUS devices from the configuration
<key>, Programming, <code>, Configuration, Modify Configuration, Manual Configuration,
From panel:
RS485 BUS, 
or:
<key>, 8, <code>, 1, 2, 2, 2
Note:
The description appears only when the device is included in the configuration.
Repeater n
in Configuration : YN
<Description repeater>
8.4.5 Adding/Deleting I/O expansion boards from the configuration
From panel: <key>, Programming, <code>, Configuration, Modify Configuration, Manual Configuration,
I/O, 
or:
<key>, 8, <code>, 1, 2, 2, 3
Local I/O
in Configuration : _O
26
to view the parameters.
<Type Description>
Enter = Confirm
<Type Description>
YN
<Type Description >
Esc=NO
S T
and to scroll the list, or type in the device number then
Ensure that "yyy" is the address the system
has assigned to the device.
Use keys S and T to change the device type.

Press to confirm and access the parameter
settings.
Use keys S and T to view the device
parameters.
Press keys W and X on the first line to view
other devices.

Press to delete the device and step back to
the previous menu.
Press Esc to exit without deleting the device.
Use keys S and T to navigate through the
repeaters in the configuration.
Use keys W and X to add or delete a repeater
from the configuration.
Use keys W and X to add or delete the I/O
expansion board from the configuration.
Programming manual
Configuring the system