Technical Data Of The Ph-9 Srm; 12 +G Stud Welding Gun - Soyer PH-9 SRM12 Operating Manual

With this stud welding gun the earth connection is integrated in the gun, in front
of the support tube insert. A separate earth connection is not needed on the work-
piece.
The gun has a lift magnet. Before welding, the stud is lifted by the lift magnet and
automatically lowered again for welding.
The height of the lift is also crucial for the weld result.
The lift height can be determined using the lift time with the aid of the stud welding
device. To do so, observe chapter "12.1.5 Setting the lift time (height of lift) in
"Setup" mode" on page 61.
The height of lift is set using the adjusting wheel on the gun (see "Figure 5: PH-9
SRM
The PH-9 SRM
stud chuck:
•
•
•
•
The gas insert serves to optimise the gas flow and insulate the stud chuck from
the shielding gas cap.
.
The PH-9 SRM
stud welding devices specified in the technical data.

9.1 Technical data of the PH-9 SRM

Technical data of the PH-9 SRM
Designation
Item no.
Welding process
Stud diameter
Stud chuck
Stud length
12
+G stud welding gun").
12
+G stud welding gun has a gas insert for each diameter of the
M6: F06738
M8: F06739
M10: F06740
M12: F06741
i
12
+G stud welding gun may only be operated with the
12
+G stud welding gun
PH-9 SRM
earth connection
P02277
•
•
M3 - M12 (depending on the stud welding device)
SRM stud chuck
Standard to 60 mm, special lengths possible on
request and with special accessories
Operating manual Soyer Bolzenschweißtechnik
Description of the PH-9 SRM
12
+G stud welding gun
12
+G stud welding gun with integrated
Drawn arc stud welding (DA)
SRM welding process
12
+G stud welding gun
37