Installing the SRM stud chuck.
Step 7:
Slide the tripod with the shielding
gas cap onto the gun.
Step 8:
Slide the stud chuck to the end stop
in the spring piston in the gun.
Step 9:
Hand-tighten the union nut.
Step 10:
Insert a stud and check the stud
protrusion.
The stud/stud flange must pro-
trude 1 - 1.5 mm out of the
shielding gas cap.
If necessary, correct the setting
of the stud chuck by shifting the
tripod.
Step 11:
Tighten the four socket head screws.
Assembly is complete.
Operating manual Soyer Bolzenschweißtechnik
Description of the PH-9 SRM
12
stud welding gun
1 - 1.5 mm
33