BMW X7 2023 Owner's Manual page 274

CONTROLS
Push the rocker switch forward or pull it back-
ward and hold for approx. 7 seconds.
When the rocker switch is released, the LED
indicates the system status.
▷ LED illuminates: the self-leveling suspen-
sion is activated.
▷ LED goes out: the self-leveling suspension
is deactivated.
The self-leveling suspension is automatically
activated after driving off at speeds above ap-
prox. 6 mph/10 km/h.
Setting the vehicle level manually
Push the rocker switch forward:
The vehicle is raised to the next highest vehicle
level.
Pull the rocker switch backward:
The vehicle will lower by one level.
LED display on rocker switch
▷ LED illuminates: Current vehicle level dis-
played.
▷ LED flashes: adjustment procedure run-
ning. The vehicle raises or lowers itself.
▷ LED flashes rapidly: The selected vehicle
level is not possible at this time.
▷ LED off: System is deactivated.
▷ All LEDs on the rocker switch are flashing:
system is initializing. The selected vehicle
level will be adjusted as required after initi-
alization.
274
Driving comfort
Online Edition for Part no. 01405A7B198 - II/23
Setting the vehicle level
automatically
While driving
The vehicle will lower automatically in the fol-
lowing situations:
▷ When switching to SPORT drive mode.
▷ At higher speeds.
When a set vehicle level is exited due to the
speed, the vehicle level will be adjusted ac-
cording to the selected driving mode.
In the event of a flat tire
When a loss of tire inflation pressure is de-
tected in a wheel, the pressure on this wheel
is reduced automatically to increase the possi-
ble distance traveled. In this situation, only the
normal level is available.
Adjusting vehicle level using button
on lower tailgate
Principle
When the tailgate is open, the button on the
tailgate can be used to lower the vehicle to
entry level and raise it again for easier loading
and unloading.
Setting the vehicle level
Press the button on the lower tailgate.
The vehicle is lowered to entry level.
Press the button again to raise the ve-
hicle.
The flashing of the LED in the button indicates
the level change.
During the raising procedure, the vehicle raises
itself from the entry level to the level that was
selected last or the normal level.
Canceling the adjustment procedure
Press the button again. The vehicle raises or
lowers itself back to the starting level.