Connector And Jumper Descriptions; Figure 2-2. Leds D4 & D5; Figure 2-3. Reset Push-Button; Table 2-1. Leds - Texas Instruments SimpleLink CC3301 User Manual

Hardware

2.2 Connector and Jumper Descriptions

2.2.1 LEDs and Push-Buttons
Table 2-1 lists the LED descriptions.
Reference
D4
D6
D5
Figure 2-2 shows the mentioned LEDs on the board.
Push-button SW1 can reset the device, as seen in
device into a shutdown state. Releasing the button brings the nReset back high and allows the device to start up
as long as power is provided to the board. This button is primarily designed for use without a hosted setup using
Radio tool, when the user wants to reset the device state for initial connection. Refer to
concerning Radio Tool.
™
6 SimpleLink CC3301 Wi-Fi 6 and Bluetooth
in Module (BP-CC3301)

Table 2-1. LEDs

Color
Green
Red
Yellow
Figure 2-2. LEDs D4 & D5
Figure

Figure 2-3. Reset Push-Button

®
Low Energy BoosterPack
Copyright © 2023 Texas Instruments Incorporated
Usage
3.3V power indication
1.8V power indication
nRESET
2-3. Press SW1 to pull the nReset line low and put the
™
Plug-
www.ti.com
Comments
On: 3.3V power rail is up
Off: no 3.3V power supplied
On: 1.8V power rail is up
Off: no 1.8V power supplied
The LED indicates the state of
the nReset pin. If that LED is
on, the device is functional which
means the nReset is high.
Section 3.3 for details
SWAU130 – MARCH 2023
Submit Document Feedback