Subscribe to Our Youtube Channel
Related Manuals for Texas Instruments CC3200MODLAUNCHXL
Summary of Contents for Texas Instruments CC3200MODLAUNCHXL
- Page 1 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware User's Guide Literature Number: SWRU397 December 2014...
-
Page 2: Table Of Contents
LaunchPad Wiki ..................Information on the CC3200MOD ....................Download CCS, IAR ....................CC3200 Code Examples .................... CC3200 Application Notes ....................The TI E2E Community Table of Contents SWRU397 – December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... - Page 3 ...................... Default I2C Addresses ......................Jumper Settings ....................... UART Signals ........................SOP Lines ....................Miscellaneous Settings ........................ Push Buttons ......................... LEDs ......................... Change Log SWRU397 – December 2014 List of Figures Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
-
Page 4: Introduction
The CC3200MOD integrates all required system-level hardware components including clocks, SPI flash, RF switch, and all required passive components. This document explains the various configurations of the CC3200MODLAUNCHXL, a low-cost evaluation platform which hosts the CC3200MOD. The module LaunchPad also features programmable user buttons, RGB LED for custom applications, temperature and accelerometer sensors, as well as onboard emulation for debugging. -
Page 5: What's Included
FCC/IC Regulatory Compliance The CC3200 SimpleLink Wi-Fi and IoT solution with MCU LaunchPad hardware is FCC Part 15 and IC ICES-003 Class A compliant. SimpleLink is a trademark of Texas Instruments. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor... -
Page 6: Hardware Description
Hardware Description www.ti.com Hardware Description Figure 1. CC3200MOD LaunchPad EVM Overview CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 7: Block Diagram
Can be powered externally, with 2xAA or 2xAAA alkaline batteries working down to 2.3V typical (typ) SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 8: Connecting A Boosterpack
For the SWD mode, only TCK and TMS need to be shorted to the CC3200MOD. When a battery is used, disconnect all JTAG headers to prevent any reverse leakage current. CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 9: I2C Connections
It has in-built reverse voltage protection to prevent the battery from being plugged in the reverse manner. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 10: Uart Signals
Note: SOP[2:0] corresponds to J15, J16, and J17, in the LaunchPad schematic design. Figure 7. SOP Jumpers CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 11: Miscellaneous Settings
To observe the Network Processor (NWP), MAC Debug Header Logs. SOP2 Isolation Isolate SOP2 (GPIO_25) from the 20 pin connector SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 12: Push Buttons
GPIO_22 will be pulled to VCC. When pushed, the GPIO_13 GPIO_13 will be pulled to VCC. CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... - Page 13 GPIO_10 and GPIO_11 are used as I2C also. So whenever the pull-ups are enabled, the LEDs would glow. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
-
Page 14: Power
When the board is powered from the USB connector, place the jumpers on the following headers, as shown in Figure J12 (shorted) CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 15: Powering From Usb
P1.1. During this mode, remove the J13 so that the on-board LDO is not overloaded. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 16: Measure Cc3200Mod Current Drawn
4. Measure the current. Note that if the current levels are fluctuating, it may be difficult to get a stable measurement. It is easier to measure quiescent states. CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 17: Measuring Active Power
4. An ammeter can also be used for this measurement, but the results may be erroneous due to the switching nature of the current. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 18: Rf Connections
Figure 13. Radiated Testing Using Chip Antenna Resistor mounted towards U.FL Murata Connector Figure 14. Board Set for Conducted Testing CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 19: Design Files
The Software Development Kit (SDK) for use with the CC3200 LaunchPad can be obtained from http://www.ti.com/tool/cc3200sdk. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 20: Software Examples
The subdirectory also has an *.ewp project file. This file can be opened into an existing workspace using Project → Add-Existing-Project…. CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 21: Additional Resources
The TI E2E Community Search the forums at e2e.ti.com. To find your answer, post your question to the community. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... - Page 22 SPACER SPACER SPACER SPACER SPACER SPACER SPACER CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
- Page 23 Please note that if User does not follow the instructions above, User will be subject to penalties of Radio Law of Japan. SPACER SPACER SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
- Page 24 However, TI does not warrant the accuracy of EVM descriptions, EVM availability or other information on its websites as accurate, complete, reliable, current, or error-free. CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor SWRU397 – December 2014 Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
- Page 25 County, Texas. Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. SWRU397 – December 2014 CC3200MOD SimpleLink™ Microcontroller and Wi-Fi® Network Processor Module - LaunchPad Hardware Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
- Page 26 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.
- Page 27 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments CC3200MODLAUNCHXL...
Need help?
Do you have a question about the CC3200MODLAUNCHXL and is the answer not in the manual?
Questions and answers