Basic Configuration Of An Nshield Nshield 5C To Use A Client - Entrust nShield 5c Installation Manual

ESN HKNETI
If the and
nShield 5c to determine what they are, and requests confirmation.
3. Do one of the following:
If you are enrolling a client with an nToken installed, run the command:
nethsmenroll --ntoken-esn <nToken ESN> [Options] --privileged <Unit IP> <Unit ESN> <Unit KNETI HASH>
If you are enrolling a client without an nToken installed, run the command:
nethsmenroll [Options] --privileged < Unit IP> < Unit ESN> < Unit KNETI HASH>
The following is an example of the output:
OK configuring hardserver's nethsm imports.
9.3.4. Configure the TCP sockets on the client for Java applications
To configure the TCP sockets on the client for Java applications (for example, KeySafe):
1. Run the command:
config-serverstartup --enable-tcp --enable-privileged-tcp
9.4. Basic configuration of an nShield nShield 5c to use a
client
Do the following:
1. On the nShield nShield 5c front panel, use the right-hand navigation button to select
System > System configuration > Client config > New client.
The following screen is displayed:
Client configuration
Please enter your
client IP address:
CANCEL NEXT
Enter the IP address of the client, and press the right-hand navigation button.
nShield® 5c Installation Guide
nethsmenroll
are not specified, attempts to contact the nShield
52 of 77