Entrust nShield 5c Installation Manual page 41

9.2.7. Edit route entry
9.2.7.1. Edit IPv4 route entry
To edit a route entry for IPv4:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > Edit route entry.
The following screen is displayed:
► 1. 1. 1. 1/ 1
3. 3. 3. 3/ 3
1111:1111:1111:1111:
1111:1111:1111:1111
/128
BACK SELECT
2. Select the IPv4 route to be edited. Press the right-hand navigation button. The
following screen is displayed:
Edit route entry
Enter the IP range
and mask length:
1. 1. 1. 1/ 1
Enter the gateway
2. 2. 2. 2
CANCEL FINISH
3. Edit the IPv4 route entry. Press the right-hand navigation button to accept the
changes.
9.2.7.2. Edit IPv6 route entry
To edit a route entry for IPv6:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > Edit route entry.
The following screen is displayed:
Edit route entry
► 1. 1. 1. 1/ 1
3. 3. 3. 3/ 3
1111:1111:1111:1111:
1111:1111:1111:1111
/128
BACK SELECT
nShield® 5c Installation Guide 41 of 77