Entrust nShield 5c Installation Manual page 35

Network configuration
Interface #2
DISABLE
CANCEL FINISH
5. Select the ENABLE option.
6. Press the right-hand navigation button to accept. A screen similar to that used for
interface #1 is displayed.
9.2.4. Configure an Ethernet bond interface
9.2.4.1. Enable or disable the use of a bond interface
1. From the front panel menu, select System > System configuration > Network config
> Set up bond > Enable/disable bond.
The following screen displays:
Network configuration
Bond Interface
DISABLE
CANCEL FINISH
2. Set the ENABLE/DISABLE field to the required option.
3. To accept, press the right-hand navigation button.
9.2.4.2. Set up a bond interface
1. From the front panel menu, select System > System configuration > Network config
> Set up bond > Configure bond.
The following screen displays:
Bond interface config
will use the eth0
IPv4 and IPv6 config
if they are enabled
CANCEL NEXT
2. Press the right-hand navigation button.
The following screen displays:
nShield® 5c Installation Guide 35 of 77