Checking The Installation; Using A Security World - Entrust nShield 5c Installation Manual

• The nShield nShield 5c Serial Console.
• The cfg-pushnethsm
5c (see the nShield nShield 5c User Guide). From the configuration file you can
configure the RFS, add clients, or change the network configuration.
• The nethsmadmin

9.7. Checking the installation

To check that the module is installed and configured correctly on the client:
1. Log in as a user and open a command window.
2. Run the command:
enquiry
For an example of the output following a successful
utility.
If you are configuring a client belonging to an nShield nShield 5c, the response to the
enquiry
command should be populated and the
mode operational
If the is
mode is initialization, the HSM has been installed correctly, but you must
If the
change the mode to operational.
If the output from the
restart your computer, then re-run the

9.8. Using a Security World

See the nShield nShield 5c User Guide for more about creating a Security World or
loading an existing one.
nShield® 5c Installation Guide
utility to push an updated configuration file to the nShield nShield
utility (see the nShield nShield 5c User Guide).
the HSM has been installed correctly.
enquiry
command says that the module is not found, first
enquiry
hardware status
enquiry
command.
command. See Enquiry
shown as OK.
59 of 77