Entrust nShield 5c Installation Manual page 39

9.2.5.2. Set default gateway for IPv6
To set a default gateway for IPv6:
1. From the front panel menu, select System > System configuration > Network config
> Set default gateway > IPv6 gateway.
The following screen is displayed:
Gateway configuration
Enter IPv6 address of
the default gateway:
CANCEL NEXT
Enter the address for the gateway. Press the right-hand navigation button. The
following screen is displayed if the address entered was a link-local address:
Gateway configuration
Select an interface for link-local address:
::
CANCEL NEXT
Select the interface for the IPv6 gateway. Press the right-hand navigation button to
accept.
9.2.6. Set up Routing
9.2.6.1. Set up routing for IPv4
To set a new route entry for IPv4:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > New IPv4 route entry.
The following screen is displayed:
Edit route entry
Enter IP range
and mask length:
0. 0. 0. 0/ 0
Enter the gateway:
0. 0. 0. 0
CANCEL FINISH
nShield® 5c Installation Guide 39 of 77