Entrust nShield 5c Installation Manual page 38

13. Set the resend igmp
This parameter is only valid for
modes.
14. To accept, press the right-hand navigation button.
The following screen displays:
Bond interface config
Are you sure you wish
to change the config ?
CANCEL CONFIRM
15. To accept and apply changes to the bond config, press the right-hand navigation
button.
The following confirmation screen displays:
Bond interface
config completed OK
CONFIRM
9.2.5. Default gateway
9.2.5.1. Set default gateway for IPv4
To set a default gateway for IPv4:
1. From the front panel menu, select System > System configuration > Network config
> Set default gateway > IPv4 Gateway.
The following screen is displayed:
Gateway configuration
Enter IPv4 address of
the default gateway:
0. 0. 0. 0
CANCEL NEXT
2. Enter the IPv4 address of the default gateway.
3. Press the right-hand navigation button NEXT and then FINISH to accept.
nShield® 5c Installation Guide
field to the required value. Range:
active backup
0 - 255.
mode. This setting is ignored in other
38 of 77