Mounting On Linear Actuators - ABB TZIDC-110 Operating Instruction

TZIDC-110, TZIDC-120 DIGITAL POSITIONER | OI/TZIDC-110/TZIDC-120-EN REV. H

Mounting on linear actuators

For mounting on a linear actuator in accordance with IEC 60534
(lateral mounting as per NAMUR), the following attachment kit is
available:
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin
(for travel 10 to 35 mm
(0.39 to 1.38 in) or 20 to 100 mm
(0.79 to 3.94 in)
5 Washers
6 Screws
Figure 8: Attachment kit
Figure 9: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws and spring washers
4
7 U-bolts
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
and clamp plates with
1 2
to the actuator stem.
3
Figure 10: Mounting lever and bracket on the positioner
1. Attach the lever 6 to the feedback shaft
positioner (can only be mounted in one position due to the
cut shape of the feedback shaft).
2. Using the arrow marks 4
within the operating range (between the arrows).
3. Hand-tighten the screw
4. Hold the prepared positioner (with the mount bracket
loose) on the actuator so that the follower pin for the lever
enters the follower guide to determine which tap holes on
the positioner must be used for the mount bracket.
5. Secure the mount bracket
using the relevant tap holes on the positioner housing.
Tighten the screws as evenly as possible to ensure
subsequent linearity. Align the mount bracket in the oblong
hole to ensure that the operating range is symmetrical (lever
moves between the arrow marks
5 of the
, check whether the lever moves
7 on the lever.
1 with screws 2 and washers
4 ).
39
1 still
3