Thermo Scientific 3403 Manual page 14

Electrical Safety
(continued)
Thermo Scientific
• Caution Warranty will not be responsible for damage caused by the use
of steel wool, chlorinated products, corrosive agents, formaldehyde,
concentrated mineral acids, high pressure steam at over 100°C, benzyl
alcohol, Methylene Chloride or other caustic agents.
• Caution Warranty will not be responsible for damage caused by
disconnecting components with the power cord still plugged into the
wall outlet.
• Caution Warranty will not be responsible for damage caused by using
an improper gas supply, such as a liquid CO2 cylinder with a siphon
tube.
• Caution Warranty will not be responsible for damage caused by
touching gas sensors.
• Caution Warranty will not be responsible for damage caused by the use
of de-ionized water in the humidity pan.
• Caution Warranty will not be responsible for damage caused by gas
input pressures exceeding 15 PSIG at the rear of the cabinet.
Caution Remote alarm contacts are rated for a maximum of 3A (amps)
•
at 125VAC.
• Note Use this product only in the way described in the product
literature and in this manual. Before using it, verify that this product is
suitable for its intended use.
Note Know the location of the incubator's circuit breakers or fuses.
•
Ensure all breakers and/or fuses are clearly marked for quick
identification and reference.
• Note Always use the correct tool for a job and be sure those tools are
in good condition. Ensure that tools to be used on electrical devices are
well insulated, if applicable.
Note Be sure to reference any applicable wiring diagram(s) when
•
reconnecting and replacing electrical components.
• Note Throughout this service manual, additional safety precautions
dealing with specific procedures may be presented. This information
should be carefully read and observed.
Section 2
Safety
Midi 40 CO2 Incubator 2-3