Table of Contents
Advertisement
Setup Procedure
6. Enter the Data Rate as "10.24G" or the desired input data rate. The Data rate value can be referenced
from the DAC39RF10EVM GUI. It is displayed on output parameter as shown in
DAC39RF10EVM
GUI.
7. For DAC Option dropdown select the "Offset Bin" option.( The DAC39RF10EVM gui always defaults to offset
binary).
8. Navigate to lower left side of the HSDCpro GUI to I/Q Multitone Generator section. For # of tones enter 1, for
Tone Center enter 1G( 1 GHz or desired frequency), # Samples can be left 65536.
9. Tone selection should be "Real", since this is JMODE0 , the DUC/ NCO is bypassed. If other JMODE was
configured, such that DUC/NCO was used the Tone selection should be "Complex".
10. Click Create Tones button and then click Send in upper left side of HSDCpro GUI. If a pop appear
mentioning the SERDES RATE click OK. The DAC should be sending the programmed frequency to the
outputs.
14
DAC39RF10EVM Evaluation Module
Figure 3-8. HSDCpro Setup
Copyright © 2023 Texas Instruments Incorporated
www.ti.com
Configuration of
SBAU395 – APRIL 2023
Submit Document Feedback
Advertisement
Table of Contents
