Connection; Version; Serial Number; Lamination Mode - Canon IX-R7000 Configuration Manual

Connection

The Connection menu displays the current connection state of the Laminator.
The below options can be set from this menu. This setting will not change automatically
depending on the connection state of the Laminator, it must be set manually by the user.
DISCONNECT ... Set when the Laminator is not connected. (Default value)
CONNECT ... Set when the Laminator is connected.
This setting will be applied after power cycling the IX-R7000.

Version

The Version menu displays the Laminator firmware version.

Serial Number

The Serial Number menu displays the Laminator serial number.

Lamination Mode

The Lamination Mode menu displays the Laminator's currently set lamination mode.
The below options can be set from this menu.
Front side ... Laminates the front side and ejects the card front side up.
Back side ... Laminates the back side and ejects the card back side up.
Front and back ... Laminates the front side, laminates the back side, and then ejects the card back
side up.
Back and front ... Laminates the back side, laminates on the front side, and then ejects the card
front side up.
Front and flip ... Laminates the front side and ejects the card back side up.
Back and flip ... Laminates the back side and ejects the card front side up.
NoLAMI(Faceup) ... Ejects the card front side up without any lamination.
6 IX-R7000 Card Lamination Module Configuration Guide