Build Zone Settings; Removing A Completed Part - Stratasys Neo 450 User Manual

Basic User Operations

Build Zone Settings

Selecting one of the build zones will display the Build Zone Settings dialog box. Here,
recoater parameters may be changed to compensate for when resin is not recoating the entire
layer. For example, changing the Sweep count from 1 to 2 will add a second recoat. This will
help to ensure proper resin recoat.

Removing a Completed Part

1. After the part completes, the elevator raises the build platform above the vat. This allows
superfluous resin to drain.
2. Manually remove the build platform from the Neo450.
3. To remove the build platform from the Neo800, use the unload cart shown in
Figure 23 (page
4. Open the front door of the Neo800 and position the unload cart in front of the printer.
Figure 22: Build Zone Settings
153).
© Copyright 2022 Stratasys. All rights reserved.
Starting a Build
Page 152