Table of Contents
Advertisement
Multi-Storage Unit
When installing multi-storage units,
install the middle storage first and
spread out to the sides.
Position storage leg over pilot
1.
holes in underside of storage
unit 1; attach storage leg by
inserting (10) #10-3/4" Pan
Head Screws into the pilot holes
and tighten, (Figure 1).
Note: For storage unit 54" wide
and up, attach single storage leg
to the middle in underside of
storage unit. Please see
Application Guide for storage
leg placement.
Repeat Step 1 to install for each
2.
leg required.
Carefully turn storage unit
3.
upright position.
Level the storage unit from
4.
front to back and side to side by
rotating the adjustable glide
counterclockwise to extend the
glide and raise the storage unit,
(Figure 2).
Note: The storage unit should
be precisely level prior to
joining other storage unit.
Continued on the next page >>
STORAGE UNIT 1
1
SINGLE STORAGE LEG
2
SHARED STORAGE LEG
3
ADJUSTABLE GLIDE
4
May 2023
Drill
Right Angle Drill
2
2
2
2
4
4
Philips Bit
Tape Measure
1
3
3
Tools & Hardware Needed
Torpedo Level
Figure 1
Figure 2
8540-1013
#10-3/4" Pan Head
Screw
halifax 49
Advertisement
Table of Contents
