Table of Contents
Advertisement
９．Reference Materials
9-1 How to Connect Sensor to the Relay Amplifier
Caution
意
Caution
注意
① Open the dust cover in the direction of the arrow.
② Pull down the sensor locking lever in the direction of the arrow.
③ Insert the sensor into the mounting holes on the amplifier.
④ Pull up the sensor locking lever back in the direction of arrow.
⑤ Close the dust cover.
Do not insert a sensor with the locking lever in a locking position.
Doing so could cause damage or failure of the devices.
Do not push the sensor too strongly against the bottom as it may
damage or break the parts inside the amplifier. Insert the sensor slowly.
33
14mm
Advertisement
Table of Contents
