Table of Contents
Advertisement
■ Toolbar
The frequently used commands are provided as buttons. The functions of individual commands
are explained below.
①
Show/Hide Template wave
②
Fit
to measurement
(selected waveform)
③
Fit to measurement voltage (all
waveforms)
④
Fit to measurement time
⑤
Fit to measurement conditions
⑥
Cursor tool
⑦
Zoom
⑧
Hand tool
■ Various buttons
4-3 Setting Conditions
Here, set the conditions under which data is retrieved. The conditions once set are saved to the
setting file, so the same conditions are automatically set when the setting file is read next and
after.
■ Set "measurement conditions", "flow front", "trigger conditions", "waveform search
algorithm" and "control output conditions" sequentially in this order.
※Set "control output conditions" as needed.
■ Setting measurement conditions
①
② ③ ④
Shows or hides the Template waveforms read into the frame screen.
voltage
Enlarges the selected waveform in the Y axis (voltage axis) direction.
Enlarges all waveforms in the Y axis (voltage axis) direction.
Reduces only in the X axis (time axis) direction.
Reduces along both the X axis (time axis) and Y axis (voltage axis).
Displays the time and voltage value at the cursor position.
Enlarges the specified view.
Drags and moves the enlarged view.
Opens settings screen (For details, see Page 16).
Executes free run (For details, see Page 29).
Stops the measurement (For details, see Page 18).
Resets the counter.
Clears control output signal manually.
⑤ ⑥ ⑦
⑧
取
扱
説
明
書
14
Advertisement
Table of Contents
