Using The System; Adjusting Light Intensity; Selecting Setting File; Starting Measurement - FUTABA MFS02 Instruction Manual

５．Using the System
The previous operations have completed the necessary preparations. Now, the user can run the system
and observe flow velocity waveforms.

5-1 Adjusting Light Intensity

■Close the mold once and check the voltage level before the resin passes over the sensor.
Adjust the light intensity of the relay amplifier in the range of 2000 to 3000 mV.
※For the operation, refer to Section 9-2-2 "Adjusting the light intensity of relay amplifier" on Page 34.

5-2 Selecting Setting File

① Press the "Settings" button.
③ Select a setting file and press "Open".
※At shipment, the default settings file (pfsconfig.xml) is stored in the PC.
※For creating and saving the setting file, refer to Section 4-3 "Setting the Conditions" on Page 14 and Section
4.4 "Saving Settings As" on Page 18.

5-3 Starting Measurement

Now, the system is completely ready to observe waveforms.
■ Measurement of flow velocity begins when a trigger signal (measurement start signal) is input from
the molding machine.
※A trigger signal can also be input manually by pressing the "SET" key of the amplifier.
■ If you need to stop the measurement during the process, press the "Stop measurement" button.
※If you stop the measurement mid-way, data file is not created.
② Press "Open" from "File" in the menu bar.
④The conditions in the selected settings are displayed.
⑤ Press the "OK" button on the upper right
to close the Settings screen.
てください。
19