Sanyo VCC-HD5600P Series Manual page 23

Before recording video, install a recording medium (SD memory card or external hard disk) on the camera and
perform the following procedures.
You can record the following videos or information on the media.
Normal recording
Alarm video recording
Backup video recording in event of a network failure
Manual video recording triggered by the emergency recording button
Access and system logs
In cases where both an SD memory card and an external hard disk drive are simultaneously
connected, the hard disk drive takes precedence.
The recorded video cannot be played back on the camera. To play back the recorded video, use the
supplied downloader software (HDC Downloader) and playback software (DLViewer) to play back the
video on the PC.
1
Click SD/HDD in the configuration menu.
On the SD/HDD screen, you can format the recording media.
Setting Item
1
SD MEMORY CARD/HDD
2
AREA (Ratio of the
recording areas)
3
SIZE/FORMAT
When finished formatting the SD memory card, close the SD MEMORY CARD screen.
2
Click
RECORDING
On the RECORDING screen, configure the recording settings as follows.
Default Setting
NO USE
NORMAL: 80 (Normal recording
storage area)
ALARM: 20 (Alarm/backup
recording storage area)
Displays the recording capacity of
the media.
in the configuration menu.
Required Setting/Operation
USE (Use the media for recording)
Change the rate between the "NORMAL" and
"ALARM" areas as needed.
Check the storage capacity and click
Quick Operation Guide 9/14
FORMAT
.