Hdmi, Monitor Out - Sanyo VCC-HD5600P Series Manual

1
In [MIC SENSITIVITY], specify the microphone sensitivity.
Select the sensitivity of the microphone connected to the camera from 8 levels.
+4, +3, +2, +1, 0, –1, –2, –3
2
In [FILTER(500Hz)], enable or disable the audio filter.
The audio filter reduces the 500 Hz or less frequency components of the audio.
A filter option with a lower negative dB value produces larger effects.
ON(-3dB), ON(-6dB), OFF
3
In [OUTPUT LEVEL], select the desired audio output level and click
Here, you specify the gain value of the audio output amplifier from the following 4 levels.
+2, +1, 0, –1
If you have the HDMI optional board installed on the camera, you need to configure the video output connector
you want to use.
You cannot output video signal from the HDMI connector and the MONITOR OUT connector at the
same time.
1
In [TERMINAL], select the video connector you want to use.
AUTO: A connected connector is detected automatically.

HDMI, MONITOR OUT

If both the HDMI and the MONITOR OUT connectors are connected in "AUTO" mode, the HDMI
connector takes precedence.
2
In [SIGNAL FORMAT], select the video size.
VCC-HD5600: 1080i, 720p, 480p
VCC-HD5600P: 1080i, 720p, 576p
You can select [SIGNAL FORMAT] only when "HDMI" is set for [TERMINAL].
SET
Working with Administrator Configuration Screens 18/77
.