Advertisement
CAP10G is intended to use with Diesel Oil, Vegetable Oil.
CAP10G must not be used with other flammable fluid such as Gasoline, Alcohol, Ethanol, Acetone, Toluene or
other solvents.
Be careful while drilling, cutting, grinding, etc. The fuel tank or other flammable fluid.
Daviteq is not responsible for compensation in case of explosion to bodily injury or property damage.
4. Note Before Installation
Read specifications thoroughly and make sure that its output are suitable to reading devices.
Power supply must be in the permitted range.
Do not take out the label and take off the lid as this will lead to the instability of the sensor and manufacturer
could deny warranty. (except cutting of sensor length within the allowed range).
Make sure all the necessary tools are ready before the installation.
CAP10G be equipped with screws. We advise customers should use stainless steel rivets to fasten
the plastic flange onto tank for all type of tanks and only using screws for the thick and hard ones.
5. Specification
Sensor length
Output
Power supply
Consumption
Working pressure
Working temperature
Accuracy
Temperature drift
Resolution
Sensor materials
Electrical connection
Housing
Process connection
Standard accessories
Certification
6. Full Package
Standard 700mm, 1000mm, optional 1200 or 1500mm. Cuttable down to 200mm.
Longer than 1500mm, suggest to use Industrial type sensor CAP10CN
240..33 ohms
8..50VDC
max 20mA
-1 .. 2 barg
-40 oC .. + 85 oC
+/- 0.5% of span (at 25 oC)
< + 0.03% of span per 10oC
1/1000 of span
Alloy & Engineering plastic
3-way connector IP67 from MOLEX with 3m shielded cable as standard
Cast alumium, IP67 protection
Plastic flange
flange, o-ring, gasket, protection covers, self-tapping screws, twisted seal, fuse & fuse
holder
CE-Marking per EN61236-1 (with test report)
Advertisement
