Quick Test; Sensor Installation - daviteq WSSFC-ULA-01 Manual

Sigfox-ready ultrasonic level sensor for trash bin

Table of Contents

1.3 Quick Test

With the default configuration, the device can quickly connect to the Sigfox Network by the following steps.

Step 1: Prepare the values of communication settings:

Device ID

Device PAC

Note: All Sigfox sensors are pre-configured with the correct RC before delivery. The settings of Device ID,

Device PAC, and RC could also be read from the device memory map. Please reference section

configuration

for details.

Step 2: Add the device to Sigfox Backend

Please refer to

this link

Step 3: Install the batteries to the device

Please refer to

this link

After installing the battery in 60 seconds, the first data packet will be sent to the Sigfox network. After receiving

the first data packet, the time of another packet depends on the value of the parameter:

CYCLIC_DATA_PERIOD. Additionally, you can use a Magnet Key to force the device to send data instantly.

Step 4: Decode the payload of receiving package

Please refer to section

1.4 Uplink Payload and Data Decoding

the measured values.

1.4 Uplink Payload and Data Decoding

For the Uplink Payload structure, please refer to

Note: Please select the right Payload document to suit the FW version of the sensor

SAFETY ATTENTION:

- ONLY REPLACE BATTERIES IN THE SAFE AREA WHERE THERE ARE NO FLAMMABLE GAS OR VAPOR

for details

for instructions on battery installation.

this

Get Devive ID on the device nameplate

Get Devive PAC on the device nameplate

for details of decoding the receiving packet to get

link.

3.2 Sensor

Table of Contents