Sensors; Safety - YUNEEC H850 Operation Manual

9. Sensors

The operator can check sensors status and also start the compass calibration in this interface,
normally it will display a green dot beside each sensor. If the dot turns red the corresponding
sensor needs to be calibrated again.
The operator can calibrate the compass by themselves, for the Gyroscope and Accelerometer
we suggest to calibrate with the assistance of the nearest YUNEEC Service centre to ensure the
best result.

10. Safety

The operator can change the drone fail safe behavior and geo-fence via this interface.
RC Loss Failsafe Trigger and Data Link Loss Failsafe Trigger
This 2 item section allows the operator to edit the drone behavior after the RC or Data Link
Loss. For the H850 drone please retain the "Disable" selection for the Data Link Loss Failsafe
Trigger. Only editing the RC Loss Failsafe Trigger is enough.