Once the later version was detected, the update process can be started.
4. GNSS RTK
In the sub menu under the GNSS RTK item the operator can enter to parameters to connect the
drone system to the CORS source. Please refer to the corresponding chapter in the quick start
Guide and this operator manual mentioned above.
5. T1 ??? Radio
There are 2 functions under this Item the Monitor function was the default interface when tap
the T1 ????? Radio button on the screen.
Monitor
Move the Joysticks, Knobs, and Sliders or press the buttons to check the controller hardware
input.
Calibration
Another function in the T1 ???? Radio item is the Calibration.
To calibrate the Joysticks and knobs please power off the drone to disconnect the drone and
transmitter.
Then switch to the calibration function by tap the calibration button, and tap the Start Calibration
button.