Other Functions Of The Plan Panel - YUNEEC H850 Operation Manual

Other functions of the Plan Panel

After entering into the Mission planning mode by tapping the Mission Route Setting icon, the File
button will be activated automatically. Beside the Waypoint other Pattern missions can be
created by tapping directly on the pop up create plan window, the operator can also save the
created flight plan or open an existing plan
Tap to add a Takeoff point on the map. Normally when the drone GPS position is
established , the takeoff point will coincide with the drone. Otherwise the operator
needs to add the takeoff point manually. This function is mostly used in planning a
waypoint flight plan. The Patten flight plan,such as survey etc. will create a takeoff point
automatically.
Add the waypoint on the map.
Add the region of interest point on the map. Tap the ROI button then tap on the map
directly to add the ROI point and set the altitude. Then the waypoints which are added
after the ROI point will point their gimbal camera towards the ROI point.
Insert new Pattern flight plan on the map.
Tap to add a Return to launch command after all the flight mission was finished.
Tap the Centre button to open the sub menu to select the centre point located on the
screen.
The same as with the waypoint function the operator
can set the altitude, delete or edit the position by going
through the menu of sub menus of the ROI Setting
panel. The flight routes marked with green colour
indicate which the ROI function is active.
Once a ROI point was set the Cancel ROI button will instead the ROI
button, click to deactivate the ROI function on the flight route, but not
delete directly.
Select a flight plan type to create.
Open or save the created flight plan
as .plan or .KML file.
Upload the flight plan to the drone.
And Download or Clear the flight plan
stored in the drone.