SOLTEK SL-85DIR3 Manual page 81

8. To change or remove a current supervisor password, choose "Set
Supervisor Password" and press <Enter>. An instruction box appears
on the screen, prompting you to enter the current password first:
[ Enter current supervisor password ]
9. Type the current password with keyboard and then press <Enter>.
An instruction box appears, prompting you to enter new supervisor
password:
[ Enter new supervisor password ]
10. If you enter a new password into the box, you will be using this new
password after you have finished and saved this new setup. Instead,
if you press <Enter> before you enter any new password into the
instruction box, another message box appears, telling you that you
have disabled the Supervisor password. That means, no password
is set for either entering BIOS Setup or system:
NOTE: If you forget or lose a supervisor password, the only
way to access the system is to clear the CMOS. All setup
information will then be cleared including the password and you
need to run the BIOS setup program again so as to reconfigure
BIOS.
[ Supervisor password disabled ]
Any Key to Continue
85
Chapter 4 BIOS Setup