10.3.1c
10.3.2 External water filter
If an external water filter is chosen, it is recommended that this is installed/replaced by an
installer. The corresponding documentation of the external water filter is leading.
► When installing an external water filter, the descaling indicator is automatically deactivated,
therefore it is recommended to descale Sprso immediately after replacing the external filter.
86
• remove the water tank from the Sprso
• put the filter in place and press as far as it will go
• fill the water tank with fresh cold non-carbonated water
• put the water tank back in the Sprso
► After installation, it must be indicated in the
programming that a water filter is being used, see section
"7.1.6 Water filter" on
page 35.