Installing The Machine And Setting Up For Operation; Hot-Water Tap - BRAVILOR BONAMAT Blr10-002 Instruction Manual

1.5 Installing the machine and setting up for operation

1. Place the machine on the work
surface. Leave a minimum of 6 cm
clear on the right-hand side so that the
door (10) can be opened.
2. Place the sticker "hot water" in the
recess above the hot water tap (17).
3. Place the required sticker (coffee,
chocolate, etc.) in the recess above
the beverage outlet (14).
4. Make sure that the machine is stable
and horizontal.
5. Check whether an earthed wall socket
and water supply are close by.
6. Connect the machine to the water
supply (via a tap) with the supplied
connection hose.
7. Open the tap.
8. Insert the plug in the earthed wall
socket.
9. Place the drip-tray (15) in front of the
machine. Put the fixing cams into the
opening (20).
− It is possible to connect a drain
hose to the drip-tray. A small spout
is provided at the rear of the
drip-tray. Drill a hole in this and
slide the hose onto it.
10. Open the door (10) on the left-hand
side with the key (19).
11. Open the cover of the machine (9).
12. Remove the covers (2.1) from the
ingredient containers. Fill the ingre-
dient containers with the special
ingredients available for these
machines.
13. Replace the cover on the ingredient
container.
14. Switch on the machine. Set switch (1)
to the 'on' position, which shows a red
indicator side at the switch
− The machine will now fill with water.
− The water will be heated.
15. The version number of the machine
appears briefly in the display (11).
4
(Inform the engineer of this number in
case of repair or maintenance.) A cup
then appears in the display, see figure 2.
16. Close the cover (9).
17. Push the door to close it.
18. Lock the door with the key (19).
19. A flashing thermometer will appear in
the top right-hand corner of the
display, see figure 3.
20. When the water is hot enough, the
thermometer will disappear from the
display.
21. Place a large, empty coffee cup under
the beverage outlet (14).
22. Press the right-hand start button
for a large cup.
23. The beverage is dispensed into the
cup. (The cup in the display flashes
while the beverage is dispensed.)
24. Discard the first two cups of beverage.
25. Replace the cup under the outlet and
push the right-hand start button
for a large cup again.
26. Check whether the taste and quantity
of the beverage are to your satisfac-
tion.
27. If the quantity and taste are correct,
repeat points 25 and 26 for small cups
by pressing the left-hand start button.
28. If the quantity and the taste are
correct for the small cups as well, the
system is ready for use.
29. If the taste and/or quantity is not
correct, proceed to chapter 1.6
Settings.
1.5.1 H -
OT WATER TAP
1. Place a cup under the hot-water
outlet (17).
2. Draw off a cup of hot water via the
hot-water tap and discard this.
The hot-water system is now ready for
use.