BRAVILOR BONAMAT SPRSO User Manual page 87

Problem description
bad milk foam
milk sputters very
much
water under the
machine
Possible cause
outlet not properly in
place
outlet not cleaned
milk connector not
properly in place
internal malfunction
milk temperature
milk connector not
properly in place
water tank not
correctly in place
drip tray and waste
bin not emptied on
time
internal malfunction
Check the following
• place the outlet in correct position,
see section 6.2.1 on page 14
• perform milk cleaning procedure,
see section 7.1.2 on page 22
• place the milk connector in correct
position, see section
• pull the plug out of the socket, wait at
least 10 seconds, plug the plug back in
» if the error persists, contact your dealer
• the optimum milk temperature is 5°C;
the warmer the milk, the poorer the quality
of foam produced
• place the milk connector in correct
position, see section
• place the water tank in correct position
• empty drip tray and waste bin and clean
the spillage
• pull the plug out of the socket, wait at
least 10 seconds, plug the plug back in
» if the error persists, contact your dealer
10.5 on page 88
10.5 on page 88
83