Installing The Machine And Setting Up For Operation; Hot-Water Tap - BRAVILOR BONAMAT Bolero 10 Operating Instructions Manual

1.5 Installing the machine and setting up for operation

1. Place the machine on the work
surface. Leave a minimum of 6 cm
clear on the right-hand side so that
the door (10) can be opened.
2. Place the sticker "hot water" in the
recess above the hot water tap (17).
3. Place the required sticker (coffee,
chocolate, etc.) in the recess above
the beverage outlet (14).
4. Make sure that the machine is stable
and horizontal.
5. Check whether an earthed wall
socket and water supply are close by.
6. Connect the machine to the water
supply (via a tap) with the supplied
connection hose.
7. Open the tap.
8. Insert the plug in the earthed wall
socket.
9. Place the drip-tray (15) in front of the
machine. Put the fixing cams into the
opening (20).
− It is possible to connect a drain
hose to the drip-tray. A small spout
is provided at the rear of the
drip-tray. Drill a hole in this and
slide the hose onto it.
10. Open the door (10) on the left-hand
side with the key (19).
11. Open the cover of the machine (9).
12. Remove the lid (2.1) from the
ingredient container. Fill the
ingredient container with the special
ingredients available for these
machines.
13. Replace the lid on the ingredient
container.
14. Switch on the machine. Set switch (1)
to the 'on' position, which shows a red
indicator side at the switch
− The machine will now fill with
water.
− The water will be heated.
15. The version number of the machine
appears briefly in the display (11).
(Inform the engineer of this number in
case of repair or maintenance.) A cup
then appears in the display, see
figure 2.
4
16. Close the cover (9).
17. Push the door to close it.
18. Lock the door with the key (19).
19. A flashing thermometer will appear in
the top right-hand corner of the
display, see figure 3.
20. When the water is hot enough, the
thermometer will disappear from the
display.
21. Place an empty coffee cup under the
beverage outlet (14).
22. Push the start button
23. The beverage is dispensed into the
cup. (The cup in the display flashes
while the beverage is dispensed.)
24. Discard the first two cups of
beverage.
25. Replace the cup under the outlet and
push the start button
26. Check whether the taste and quantity
of the beverage are to your
satisfaction.
27. The beverage maker is ready for use
when the taste and quantity of the
beverage are satisfactory.
28. If the taste and/or the quantity are
unsatisfactory, proceed to chapter 1.6
SETTINGS.
1.5.1 H -
OT WATER TAP
1. Place a cup under the hot-water
outlet (17). Draw off a cup of hot
water via the hot-water tap and
discard this.
2. The hot-water system is now ready
for use.
.
again.
Fig. 2
Fig. 3