Panel Descriptions; Front Panel; Rear Panel; Spare Fuses (Fgb10A) - Icom ID-RP4000V Instruction Manual

Front panel

■
q POWER SWITCH [POWER]
Push to turn ON the power.
w POWER INDICATOR
Lights when the power is turned ON.
e HIGH/LOW POWER SELECT SWITCH [H/L]
Select either High (approximately 25 W) or Low (ap-
proximately 2.5 W) output power.

Rear panel

■
q
q RECEIVE ANTENNA CONNECTOR [RX ANT] (p.
5)
Connect a 440 MHz band antenna separately, or
through a duplexer.
w TRANSMIT ANTENNA CONNECTOR [TX ANT]
(p. 5)
Connect a 440 MHz band antenna separately, or
through a duplexer.
e COOLING FAN
NOTE: Keep the area around the fan free from
obstacles.
r POWER CONNECTOR [DC13.8V] (p. 5)
Connect to the ID-RP2C with the supplied DC power
cable (OPC-1309) to supply the DC power.
q w e r t

PANEL DESCRIPTIONS

r SERVICE CONNECTOR T [SERVICE T] (p. 27)
Connect a PC with an A-B type USB cable to set the
transmit frequency. (User supplied cable)
t SERVICE CONNECTOR R [SERVICE R] (p. 27)
Connect a PC with an A-B type USB cable to set the
receive frequency. (User supplied cable)
w
t [CONT I/O] (p. 5)
Connect to the ID-RP2C with the supplied control
cable for serial data communications.
y GROUND TERMINAL [GND] (p. 4)
Connect to a ground to prevent electrical shocks,
TVI, BCI and other problems.
2
e r t y
2