Attaching Drive Or Output Elements To The Gearbox Shaft - Siemens SIMOTICS S-1FG1 Operating Instructions Manual

6.7

Attaching drive or output elements to the gearbox shaft

NOTICE
Damage to shaft sealing rings caused by heating
When mounting input and output elements using heat treatment, shaft sealing rings can be
damaged due to overheating.
• Use thermal shields to protect shaft sealing rings against overheating above 100 °C due to
Observe the installation or operating instructions when installing.
Unless otherwise specified, heat up the input and output drive elements either inductively,
using an open-flame torch or in an oven.
Use the centering holes in the shaft end faces.
Use a pulling-on device to attach input or output elements.
Figure 6-1
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 12/2022, A5E47360747B/RS-AC
radiated heat.
Example of a pulling-on device
6.7 Attaching drive or output elements to the gearbox shaft
Mounting and assembly
101