Siemens SIMOTICS S-1FG1 Operating Instructions Manual page 169

Injuries when lifting and transporting
Incorrect lifting and transport operations, as well as devices and equipment that are unsuitable
or damaged can result in death, severe injury and/or material damage.
• Lifting devices, transport vehicles and load suspension devices must comply with
• The load carrying capacity of the lifting equipment and the load suspension device must
• Do not attach any additional loads to the lifting equipment.
• To hoist the servo geared motor, use suitable cable-guidance and/or spreading equipment,
• Servo geared motors must not be lifted or transported using the power connector or signal
• Do not stand in the slewing range of hoisting gear or under suspended loads.
Injuries caused by falling servo geared motors
The threads for lifting eyebolts in the motor enclosure are not designed for carrying the entire
servo geared motor.
If you lift the servo geared motor only using the lifting eyebolts in the motor enclosure, the
lifting eyebolts can be ripped out of the threads and cause death or serious injury and result in
death or severe injuries.
• For transport, screw the lifting eyebolts into the threads in the gearbox housing depending
• Use the threads for the lifting eyebolts in the motor enclosure only for position stabilization.
• Observe the maximum load of the lifting eyebolt as listed in the table below.
Injuries as a result of suspended loads
When transporting, movement of the servo geared motor can result in injuries.
• Only use hoisting gear and load suspension devices that are in perfect condition and have
• Never stand under suspended loads or in their slewing range.
• After the servo geared motor has been placed down, ensure that it cannot roll.
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 12/2022, A5E47360747B/RS-AC
WARNING
requirements.
correspond to the weight of the servo geared motor (see the rating plate).
particularly if the motor is equipped with mounted parts and components.
connector.
WARNING
on the position.
WARNING
been designed for the weight of the servo geared motor.
Service and maintenance
11.1 Safety instructions
167