Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Bracket and Shaft Installation
ASSEMBLY INSTRUCTIONS
Bracket and Shaft Installation
1.
Insert shaft into the coupling with the key in the key-way.
2. Ensure shaft is seated completely into the coupling.
3. Install the motor bracket to the build fixture by aligning bracket
holes with four hubs on fixture.
4. Install the shaft onto the fixture, ensuring the coupling is com-
pletely seated on the shaft stub.
•
Support table set up may vary, but access below the table
is recommended to secure shaft to build fixture.
5. Insert assembly fixture bolt from bottom of fixture. Screw into
coupling with Allen wrench until tight.
.
Pump Size
Screw Description
M8 x 1.25 x 100 mm
6"
M8 x 1.25 x 140 mm
8" & 10"
M8 x 1.25 x 140 mm
4
Advertisement
Table of Contents
