Franklin Electric SSI Series Assembly Manual page 7

5. Use a rubber hammer to tap the strap down to ensure it is com-
pletely seated.
6. Repeat steps 1 - 5 for each strap.
7. Slide washer onto the stud and thread nut for each strap.
8. Tighten to the correct torque.
• Refer to table below.
• Tightening in a crisscross pattern is recommended to main-
tain even torque on all sides.
• For 10" models, place Strap Blocks on motor bracket to
prevent strap twisting during installation and tightening
process.
NOTE: The stainless steel strap nuts have been anodized to pre-
vent galling.
Pump GPM Torque (Nm)
85
150
225 45
300
360
425
80
475
550
625
120
825
1150
ASSEMBLY INSTRUCTIONS
Strap Installations
7