Service Instructions; Replacement Parts - Franklin Electric Little Giant PE-1 Owner's Manual

SERVICE INSTRUCTIONS

WARNING
MAKE CERTAIN THAT THE UNIT IS DISCONNECTED FROM THE POWER SOURCE BEFORE ATTEMPTING TO SERVICE OR REMOVE ANY
COMPONENT.
NOTE: This unit is permanently lubricated. Oiling is not required.
1.
Be certain the power cord is in good condition and has no nicks or cuts. The power cord on these units cannot be replaced. In case of damage the whole unit must be
replaced.
2.
Remove the intake screen (item 1) from the pump. Screen is snapped on and can be removed by pulling on it.
3.
Remove the three screws (item 2) that secure the volute to the pump housing. (DO NOT remove other screws that may be exposed.)
4.
Remove the volute (item 3) and the gasket (item 5). DO NOT remove the impeller (item 4).
5.
Lightly clean any corrosion or debris which may clog the impeller. Use a brush and penetrating oil and lightly scrape to remove encrusted material.
6.
Turn the impeller by hand to make sure it turns freely. Set the pump down so the pump and impeller are not touching anything. Plug the unit into the GFCI circuit for
10 seconds to see if the impeller turns.
•
If it is rotating and GFCI did not trip, unplug unit and install parts in reverse order in which they were removed.
•
If the impeller does not rotate, if pump is tripping circuit breakers, or if pump is not operating properly after being cleaned, return the pump to an authorized
service center. DO NOT attempt repairs yourself.

REPLACEMENT PARTS

Item Part No. Description
1 118901 Intake screen
2 902417
3 101375 Volute, smooth
3 118340 Volute, hooded
4 118441 Impeller
5 101604 Gasket
Note: Only the part numbers shown can be purchased for replacement.
6
| EN
Catalog Number
PE-1 PE-1H PE-1F-IF
518200 518203
1 1
Screw 3 3
1 -
- 1
1 1
1 1
518039
1
3
1
-
1
1