Strap Installations - Franklin Electric SSI Series Assembly Manual

ASSEMBLY INSTRUCTIONS

Strap Installations

5. Repeat the steps to install next diffusers until you reach the dis-
charge assembly.
• Insert impellers (A).
• Adjust as indicated using a torque wrench and the torque
chart indicated for each pump (B).
• When sliding the different diffusers to cover the impeller
(C) and thereafter, check the alignment to the welding
point in the diffusers for a better final appearance (D).
NOTE: On all subsequent impellers using upthrust collet nut,
use two flathead screwdrivers between the collet nut and
impeller to pry down on the impeller and force it lower into the
pump shaft for proper seating.
Strap Installations
1. Install the upper diffuser (does not contain wear ring) and the
discharge.
• Make sure to align the strap locations on the discharge
with the holes in the motor bracket.
• Depending on the size of pump, the slot may have a differ-
ent configuration and location on the discharge.
2. Apply anti-seize (White Knight) to the threaded studs on the
strap.
3. Insert strap into slot so it is completely seated.
4. Slide threaded stud into motor bracket mounting hole.
• Ensure the stud extends through the hole.
6