Franklin Electric SSI Series Assembly Manual page 10

ASSEMBLY INSTRUCTIONS
Cable Guard Assembly
4. Use the small flat-head screwdriver to gently raise the strap on
the opposite side of the cable guard.
5. Gently tap the other tab under the strap.
• Remove the screwdriver after the cable guard tab has
started under the strap.
6. Make sure the cable guard is centered between the two straps.
7. Repeat steps 3-6 for all the tabs except the top two.
8. After all but the top two tabs have been installed, gently tap the
top end of the cable guard down toward the motor bracket.
• Be careful not to damage or bend the cable guard.
9. Apply pressure to the end of the cable guard while tapping on
the top side of the tabs close to the motor bracket. This will
allow for the end of the cable guard to slide under the motor
bracket ears.
10. Gently tap the cable guard to drive one of the top two cable
guard tabs under the strap.
10