ASSEMBLY INSTRUCTIONS
Nameplate Installation
Nameplate Installation
1.
Fill out nameplate data.
2. For 6" pumps, install the nameplate by inserting drive rivets
(supplied) into the two pre-drilled holes located on the motor
bracket.
3. For 8" and 10" pumps, attach nameplate to the suction screen
with two #6 machine screws and lock nuts (supplied).
•
Nuts will be on the inside of the screen to eliminate possi-
ble interference with or catching on the casing during
installation.
franklinwater.com
Mi9048 Rev 002 10-20