Franklin Electric S & J SERIES Owner's Manual

Before Installation be sure to read all the instructions and
warnings carefully. Refer to the product data plates for additional
operating instruction and specifications.
INSPECTION
Examine the equipment when received. Notify your dealer or carrier
of any damage or missing parts. Verify that the equipment is of size
and model specified.
READ AND FOLLOW
SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
WA R N I N G
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
Carefully read and follow all safety instructions in this manual
and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
Wire motor for correct voltage. See "Electrical" section of
this manual and motor nameplate.
Ground motor before connecting to power supply.
Meet National Electrical Code, Canadian Electrical Code, and
local codes for all wiring.
Follow wiring instructions in this manual when connecting
motor to power lines.
IMPORTANT SAFETY
INSTRUCTIONS
When installing and using this electrical equipment, basic safety
precautions should always be follows, including
the following:
S & J SERIES PUMP
OWNER'S MANUAL
words and be alert to the potential for
personal injury:
D A N G E R warns about hazards
that will cause serious personal
injury, death or major property
damage if ignored.
W A R N I N G warns about hazards
that can cause serious personal
injury, death or major property
damage if ignored.
C A U T I O N warns about hazards
that will or can cause minor personal
injury or major property damage
if ignored.
The label NOTICE indicates special
instructions, which are important but not
related to hazards.
READ AND FOLLOW
ALL INSTRUCTIONS
W A R N I N G To reduce the risk of injury, do not permit children to
use this product unless they are closely supervised at all times.
W A R N I N G Risk of Electric Shock. Connect only to a branch
circuit protected by a ground-fault circuit-interrupter (GFCI). Contact
a qualified electrician if you cannot verify that the circuit is protected
by a GFCI.
The unit must be connected only to a supply circuit that is protected
by a ground-fault circuit-interrupter (GFCI). Such a GFCI should be
provided by the installer and should be tested on a routine basis. To
test the GFCI, push the test button. The GFCI should interrupt power.
Push the reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI interrupts
power to the pump without the test button being pushed, a ground
current is flowing, indicating the possibility of an electric shock. Do not
use the pump. Disconnect the pump and have the problem corrected
by a qualified service representative before using.
C A U T I O N This pump is for use with permanently-installed
pools and may also be used with hot tubs and spas if so marked.
Do not use with storable pools. A permanently-installed pool is
constructed in or on the ground or in a building such that it cannot
be readily disassembled for storage. A storable pool is constructed
so that it is capable of being readily disassembled for storage and
reassembled to its original integrity.
W A R N I N G Do not install within an outer enclosure or beneath
the skirt of a hot tub or spa.