Enable/Disable Data Formatter - Newland NLS-FM50 User Manual

Enter Setup

Enable/Disable Data Formatter

When Data Formatter is disabled, the data format you have enabled becomes invalid.
** Disable Data Formatter
You may wish to require the data to conform to a data format you have created. The following settings
can be applied to your data format:
Enable Data Formatter, Required, Keep Prefix/Suffix: Scanned data that meets your data format
requirements is modified accordingly and gets outputted along with prefixes and suffixes (if prefix and
suffix are enabled). Any data that does not match your data format requirements generates an error
beep (if Non-Match Error Beep is turned ON) and the data in that barcode is not transmitted.
Enable Data Formatter, Required, Drop Prefix/Suffix: Scanned data that meets your data format
requirements is modified accordingly and gets outputted without prefixes and suffixes (even if prefix and
suffix are enabled). Any data that does not match your data format requirements generates an error
beep (if Non-Match Error Beep is turned ON) and the data in that barcode is not transmitted.
Enable Data Formatter, Not Required, Keep Prefix/Suffix: Scanned data that meets your data format
requirements is modified accordingly and gets outputted along with prefixes and suffixes (if prefix and
suffix are enabled). Barcode data that does not match your data format requirements is transmitted as
read along with prefixes and suffixes (if prefix and suffix are enabled).
Enable Data Formatter, Not Required, Drop Prefix/Suffix: Scanned data that meets your data format
requirements is modified accordingly and gets outputted without prefixes and suffixes (even if prefix and
suffix are enabled). Barcode data that does not match your data format requirements is transmitted as
read along with prefixes and suffixes (if prefix and suffix are enabled).
** Exit Setup 118