Welbilt CONVOTHERM OES mini 6.06 User Manual page 73

6 Servicing procedures
Errors and required responses (easyTouch)
The following table lists the errors that you may be able to resolve yourself. If the combi oven contin‐
ues to display the error after you have tried to resolve it, please contact customer service.
Always contact customer service for help if any error messages appear that are not listed here.
Error Refer‐
code ence
3 E25.0
5 E21.0
6 E22.1
7 E22.2
8 E22.3
9 E22.4
12 E25.1
14 E21.1
15 E29.1
16 E29.2
17 E29.3
18 E29.4
21 E15.0
23 E11.0
24 E02.0
25 E12.1
26 E12.2
27 E12.3
28 E12.4
29 E03.0
30 E96.0
31 E99.0
32 E99.9
User manual
Description of error
Condenser sensor (B3) open circuit
Oven sensor (B6) open circuit
Core temperature probe (B10) open circuit
Condenser sensor (B3) has a ground fault
Oven sensor (B6) has a ground fault
Core temperature probe (B10) has a
ground fault
Over-temperature detected by condenser
sensor (B3)
Over-temperature detected by oven sensor
(B6)
Wiring compartment too hot
Over-temperature detected by core tem‐
perature probe (B10)
Fan fault / Motor TP (thermal cutout) has
tripped or fault in frequency converter
Communication error between SM and BM
Communications interface fault
General initialization error
Required response
Contact customer service
Contact customer service
Contact customer service
Contact customer service
Contact customer service
Contact customer service
Open water supply
■
Contact customer service
■
Contact customer service
Clean fluff filter on the rear of the
■
appliance
Clear air intake at rear of appliance
■
Contact customer service
■
Correct the sensor position
Check fuse in building
■
Contact customer service
■
Unplug the appliance for approx.
■
10 seconds and restart
Contact customer service
■
Unplug the appliance for approx.
10 seconds and restart
73