Mid-Mount Attachment Stop - Toro Field Pro 6040 Service Manual

Mid-Mount Attachment Stop

g413825
1. Stop pin (2 each)
2. Top plate
3. Spacer (4 each)
Removing the Mid-Mount Attachment Stop
Installing the Mid-Mount Attachment Stop
Field Pro® 6040
22267SL Rev A
4. Center lift cylinder
5. Lower plate
6. Stop plate
Refer to Figure 89 for this procedure.
1. Park the machine on a level surface, Engage the parking brake, lower the
mid-mount attachment to the ground, set the key switch to the O
and remove the key from the switch.
2. Remove the stop pins from the mid-mount attachment stop.
3. Remove the fasteners and spacers securing the top plate to the lower plate.
4. Remove the fasteners securing the front of the stop plate to the lift cylinder.
5. Remove the four (4) fasteners securing the lower plate to the lift cylinder.
6. Inspect the plastic bushing attached to the stop plate for wear or damage and
replace if necessary.
1. Assemble the plastic bushing and indicator to the stop plate if necessary.
The indicator tab must point to the front of the stop plate and slide freely
in the top plate slot..
Figure 89
Page 7–15
7. Plastic bushing
8. Indicator
FF
Chassis: Service and Repairs
position