Installing The Attachment Mount - Toro 316000001 Operator's Manual

Figure 8
1. Locknut (3/8 inch)
2. Weight bracket
3. Left mounting bracket
8. Install a flat weight to the weight bracket and
move it rearward, flush with the bracket
9).
Figure 9
1. Keyed cross bar
2. Flat weight
g014879
4. Bolt (3/8 x 1 inch)
5. Right mounting bracket
(Figure
g014880
3. Suitcase weight
9. Install a suitcase weight in front of the flat weight
(Figure 9).
10. Secure the weights to the weight bracket with a
keyed-cross bar
rotate it 90 degrees downward to lock it in place.
11. Once you have installed all the weights and
brackets, check that all the fasteners are tight.
Tighten as necessary.
Important:
Whenever you remove the bagger
attachment, remember to remove the front weights
to return the proper stability to the machine.
3
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket (For 2015 and newer models)
2
Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
1 Draw-bar decal
For 2015 and Newer Models Only
Note:
The stabilizer bracket is used only on 2015
and newer models (Figure
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch)
7
(Figure 9). Install the bar and
10).
(Figure 10).