Advertisement
Hydraulic Fluid Cooler
g410289
1.
Shroud bracket
2.
Fan shroud
3.
Foam seal
4.
Tee fitting
Removing the Hydraulic Fluid Cooler
Field Pro® 6040
22267SL Rev A
5.
Elbow fitting
6.
Cooler cover
7.
Flange head screw (2 each)
8.
Foam seal
Refer to
Figure 46
for this procedure.
1. Park the machine on a level surface, engage the parking brake, set the key
switch to the O
position and remove the key from the key switch.
FF
2. Remove the operator's cushion.
3. Remove the fasteners securing the bottom of the cooler assembly to the
machine frame.
4. Remove the fasteners securing the cooler cover to the fan shroud and
remove the cooler cover.
5. Drain the hydraulic reservoir; refer to the traction unit Operator's Manual.
6. Clean the area around the hydraulic hose and fitting connections then
disconnect or remove the hydraulic hoses from the cooler. Cap or plug
the disconnected hydraulic tubes and fittings to prevent hydraulic system
contamination.
7. Remove the fasteners compressing the rubber clamps and remove the
cooler from the fan shroud.
8. Remove the hydraulic fittings from the cooler if necessary and discard the
fitting O-rings.
Figure 46
10.
11.
Page 5–59
9.
Rubber clamp (2 each)
Hydraulic fluid cooler
Foam seal
Hydraulic System: Service and Repairs
Advertisement
Chapters
Troubleshooting
