Installing The Attachment Mount - Toro 79398 Operator's Manual

9. Install a flat weight to the weight bracket and
move it rearward, flush with the bracket
11).
1. Keyed crossbar
2. Flat weight
10. Install a suitcase weight in front of the flat weight
(Figure 11).
11. Secure the weights to the weight bracket with a
keyed crossbar (Figure
rotate it 90 degrees downward to lock it in place.
12. Once all the weights and brackets have been
installed, check that all the fasteners are tight.
Tighten as necessary.
Important:
Whenever you remove the
bagger attachment, remember to remove the
front weights to return the proper stability
to the machine.
13. If you are installing this bagger on a machine
equipped with MyRIDE, perform the following
steps:
A. Install the previously removed 2 rail guards
using the 6 hex-washer head screws (1/4 x
13/16 inch) as shown in
Figure 11
3. Suitcase weight
11). Install the bar and
Figure 4.
B. Install the previously removed bolt and nut
(Figure to the front shock; refer to
2
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2
Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
1 Drawbar decal
Procedure
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
g014880
locknuts (5/16 inch) as shown in
1. Stabilizer bracket
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in
the machine frame using 2 bolts (5/16 x 1 inch)
and 2 locknuts (5/16 inch).
8
Figure
Figure 12
3. Locknut (5/16 inch)
Figure 13. Secure the pivot frame to
3.
Figure 12.
g030494